The Aspire CE5-S BVC Clearomizer is compatible with all EGO Batteries and comes ready to fill with your favorite e-liquid flavour! No syringe needed to fill, just unscrew tip then fill with your e-liquid and screw tip back on and you're ready for the best esmoking experience ever. These are the best design clearomizers you can buy, easy to fill, great flavor and vapour with no leaking. The difference between the Aspire CE5 BVC and the CE5-S BVC is that the CE5-S has a black exterior while the CE5 BVC tank has a translucent exterior so you can see through window to where you liquid is.
The EGO Clearomizer sometimes referred to as the tank is an atomizer and clear cartridge in one. You'll now be able to know when to refill you electronic cigarette with e-liquid to avoid running out. It's very easy to refill with a large 1.6ml capacity and measurement markings on the transparent body to indicate e-liquid level.
1 x Aspire CE5-S BVC Clearomizer with pre-installed 1.8ohm coil
-Very easy to refill just need to unscrew the tip
-Compatible with all other EGO -batteries
How to fill EGO Clearomizer:
- Unscrew tip from the clearomizer
- Fill with up to 1.8ml by tilting the clearomizer at a slight angle and dripping e-liquid in.
- Screw the tip back in clearomizer.
- Allow 1-2 minutes for the E-Juice to feed into the coil before you start to Using.
- Screw clearomizer onto battery and you're ready to vape.
How to replace Atomizer:
- Unscrew the bottom of clearomizer
- Pull out the inside of the clearomizer
- Hold one end with one hand and with other hand unscrew the atomizer (pointy end)
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil/Wire Type||Cotton, Kanthal|
|Draw Type||Mouth To Lung (MTL)|
|Tank Base Diameter||N/A|
|Thread Type||EGO Thread|
|Airflow and Filling Method||Bottom Fill, Bottom Airflow|