Vaporesso’s Gemini Sub-Ohm Tank is a spinoff version of their Gemini RTA Tank. If you enjoyed the functions of the Gemini RTA but don’t want to bother with rebuildables the Gemini Tank is perfect for you. It holds 3.0ml of e-liquid and has a top filling system for easy and convenient refilling. For maximum airflow control the Gemini Tank has adjustable airflow on the top and bottom of the atomizer and comes with a Derlin wide-bore drip tip. A great feature of Gemini Tank is that uses Stainless Steel (SS316L) cCell ceramic coil atomizers which are compatible with temperature control and wattage modes. These ceramic coils are known for their pure flavour, longevity, minimal spit-back and dry hits. If you experience a burnt taste you can recover your ceramic coil by taking a few primer puffs. This means inhale without pressing the fire button. Sucking the air should pull juice into your coil and you will know this is working once you see some air bubbles. With regular kanthal coils once you've experienced a burnt taste you need to change your coil as its unrecoverable. To maximize conductivity, it utilizes a gold plated 510 pin.
Features & Specs:
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible. For Ceramic Coils the process is very similar however they require a longer to saturate before you take your first puff.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a 20-30 minutes, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil/Wire Type||Ceramic, Kanthal, Stainless Steel (SS316)|
|Draw Type||Direct Lung (DL), Sub Ohm|
|Watts/Temp||14w-25w, 20w-40w, 50w-70w , 40w-85w|
|Tank Base Diameter||22mm|
|Thread Type||510 Thread|
|Airflow and Filling Method||Top-Fill, Bottom Airflow, Adjustable Airfow|