Vaporesso cCell-GD 0.6ohm Coils
The Vaporesso cCELL-GD-SS 0.6ohm Coils are a real game changer. The 0.6ohm Coils are recommended to be used between 8W-13W. cCell-GD-SS are made of ceramic material and stainless steel heating elements that deliver the truest taste of your e-juice in comparison to cotton wicks which can taint your hit as it is easily burn out. CCELL-GD-SS can handle much higher heat than regular cotton coils, producing more vapour and true taste, without any unpleasant burning. Ceramic coils should have a longer lifespan compared to regular kanthal coils. If you experience a burnt taste you can recover your coil by taking a few primer puffs. This means inhale without pressing the fire button. Sucking the air should pull juice into your coil and you will know this is working once you see some air bubbles. With regular kanthal coils once you've experienced a burnt taste you need to change your coil as its unrecoverable.
The cCell-GD-SS 0.6ohm coilswill satisfy vapers looking for a Mouth to lung ("MTL") draw. A MTL is commonly associated with how a tobacco cigarette is smoked. It is when a user draws the vapour into their mouth first and then inhales it into their lungs.
Please Note: The CCELL-GD-SS can be run in both wattage mode and temperature SS mode.
1 x Pack of Replaceable cCell-GD-SS 0.6ohm Coils 8W-13W (5pcs/pkg)
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible. For Ceramic Coils the process is very similar however they require a longer to saturate before you take your first puff.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a 20-30 minutes, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil OHM||0.6 OHM|
|Coil/Wire Type||Stainless Steel (SS316)|
|Compatible Tank||Vaporesso Guardian Tank, Vaporesso Target Mini Tank|
|Draw Type||Direct Lung (DL), Sub Ohm|