Aspire K2

The Aspire K2 Tank uses the same bottom vertical coil (BVC) technology as the Aspire Nautilus series tanks but in a smaller coil design. A BVC technology provides a thicker, richer vapour which in turn promotes better flavour. The K2 tank has 1.8ml of e-liquid capacity and is recommended for those looking for a mouth to lung (MTL) vape which is commonly associated with how a cigarette is smoked. It has a glass tank for extra durability and a sleek look. It has a built in adapter making it compatible with any device that has a 510 thread. It comes with a 1.6ohm coil and should be run between 3.0-4.2Volts.
Included:
1 x Aspire K2 Tank with pre-installed 1.6ohm coil
Features and Specs:
-Easy to refill
-Easy coil replacement
-Pyrex glass tube with 1.8ml liquid capacity
-Aspire BVC technology
-Kanthal coil wrapped with organic cotton wick
-Four large juice holes
-Resistance: 1.6 ohms (3.0V to 4.2V)
-Four fixed airflow holes at the base
-Removable 510 drip tip
-Height: 59mm
-Diameter: 15mm
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
Colour | N/A |
---|---|
Coil/Wire Type | Cotton, Kanthal |
Draw Type | Mouth To Lung (MTL) |
Brand | Aspire |
Watts/Temp | 10w-16w |
Tank Base Diameter | N/A |
Thread Type | 510 Thread |
Airflow and Filling Method | Bottom Fill, Bottom Airflow |
Tank Capacity | 2ml |