Aspire Atlantis EVO Extended

The Aspire Atlantis EVO Extended Tank has double wicking efficiency combined with lower positioned wick points allowing for ultra-efficient juice flow. This design allows for high VG e-liquid to move faster to the coil system and is great for thick vapor production. The Extended EVO comes with a 2ml pyrex as well as a 4ml pyrex for those looking to increase your juice capacity. It also includes 0.4Ω and 0.5Ω Kanthal Clapton coils for an optimized vaping experience.
Having an option for coils allows you to find your preferred taste when using a wide selection of e-liquid flavours. The 0.4Ω coils have a larger airflow for greater vapor production and balanced flavor while the 0.5Ω coils produce a denser vapor highlighting the flavour differently. The Atlantis EVO will satisfy vapers looking for a direct to lung ("DTL") draw. Direct to lung inhale is drawing in the vapour directly to lungs similar to smoking a shisha or hookah as opposed to a traditional cigarette. The vapour is dense, produces big clouds and is commonly referred to as “sub-ohm vaping”. Sub-ohm can be defined as a coil that is below 1.0ohm.The higher density vapour will give a more intense throat hit so it’s important to reduce the level of nicotine to 3-6mg or it may be too strong. Also it’s good to take into consideration the VG/PG (Vegetable Glycerin/Propylene Glycol) consistency of your e-liquid. It’s best to use an e-liquid that has a lower PG ratio and a higher VG ratio. PG provides a harsher throat hit, while VG adds to vapour density.
The Atlantis EVO tank is also compatible with Atlantis, Triton & Vaporesso coils.
Each Aspire Atlantis EVO Extended comes with a silicone cuff that helps disperse heat. It is also compatible with the Aspire Cleito.
Included:
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
Colour | N/A |
---|---|
Coil/Wire Type | Cotton, Ceramic, Kanthal, Clapton |
Draw Type | Direct Lung (DL), Sub Ohm |
Brand | Aspire |
Watts/Temp | 10w-16w, 14w-25w, 20w-40w, 40w-85w |
Tank Base Diameter | 22mm |
Thread Type | 510 Thread |
Airflow and Filling Method | Top-Fill, Bottom Airflow, Adjustable Airfow |
Tank Capacity | 2ml, 4ml, Glass Extension |