Joyetech ProCore Aries
Joyetech's newest sub-ohm tank the ProCore Aries is designed for both direct to lung (DTL) and mouth to lung (MTL) vapers. The ProCore Aries features a new and convenient flip open top cap for easy refilling. It has a juice capacity of 4ml and also includes a 2ml glass for vapers looking for a low profile look. The ProCore Aries has a dual adjustable airflow slot for increased vapor production when vaping at a higher wattage. The ProCore Aries tank stands out from the rest with compatibility to be used for MTL and DTL vaping with its various coil options allowing DTL vapers to reach as high as 110 watts or MTL vapers as low as 25 watts. It includes (1) ProC1 0.4ohm and (1) ProC4 0.15ohm coil specifically designed for direct to lung vaping as well as (1) ProC1-S 0.25ohm atomizer head designed for a mouth to lung vaping experience. Another unique feature of the ProCore Aries is that it is also compatible with TFV8 Baby Beast atomizer heads . The ProCore Aries has a good balance of flavour and vapor making it a great option for a novice or even an advanced vaper..
1 x ProC1 (0.4ohm) head - Pre-installed
1 x ProC1-S (0.25ohm) head
1 x ProC4 (0.15ohm) head
1 x Spare 2.0ml glass tube
1 x Manual
1 x Warranty card
Features and Specs:
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the centre of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil/Wire Type||Cotton, Kanthal|
|Draw Type||Direct Lung (DL), Sub Ohm|
|Watts/Temp||20w-40w, 40w-85w, 50w-70w , 70w-100w|
|Tank Base Diameter||25mm|
|Thread Type||510 Thread|
|Airflow and Filling Method||Top-Fill, Bottom Airflow, Adjustable Airfow|