Freemax Mesh Pro Quadruple Mesh Coil-0.15ohm

Freemax Mesh Pro Quadruple Mesh Coil-0.15ohm

Geekvape Flint Coils-1.6ohm

Geekvape Flint Coils-1.6ohm

Vaporesso EUC 0.6ohm Mesh Tea Fiber Coils

Vaporesso EUC 0.6ohm Mesh Tea Fiber Coils

Freemax Mesh Pro Quadruple Mesh Coil-0.15ohm

CA$19.99
Availability: In stock
Only 9 left
SKU
Freemax Mesh Pro Quadruple Mesh Coil-0.15ohm
Reward Points You will earn 49 Points for purchasing this product.

The Freemax Mesh Pro Quadruple coils come in a pack of 3 and is meant to be used for the Freemax Mesh Pro tank. These coils are read at 0.15Ω with 4 Kanthal Mesh Coils built in rated between 80w-120w.

Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.

Step 1. Drop e-liquid in the centre of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.

Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.

Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.

More Information
Coil OHM 0.15 OHM
Coil/Wire Type Cotton, Mesh
Brand FreeMax
Compatible Tank Freemax M-Pro
Draw Type Direct Lung (DL), Sub Ohm
Watts/Temp 80w-120w
We found other products you might like!