The Horizontech Falcon M1+ 0.16ohm coil are replacement coils for the Horizontech Falcon King Tank. They are rated for 75w of power and utilizes a vertical mesh coil wicked with bamboo fiber.
3 x Falcon M1+ 0.16ohm Coil (Rated for: 75w)
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil OHM||0.16 OHM|
|Coil/Wire Type||Cotton, Mesh, Tea Fiber|
|Compatible Tank||Horizontech Falcon King|
|Draw Type||Direct Lung (DL), Sub Ohm|