SMOK Prince V12 Triple Mesh Coils
The SMOK TFV12 Prince Replacement Coils are designed for high-powered configurations that are ONLY compatible with the undisputed vapor powerhouse SMOK TFV12 Prince
The V12 Triple Mesh atomizer heads feature a triple cylinder setup that is designed to produce smooth flavour for the experienced vaper. The V12 Prince Triple Mesh are 0.15 ohm coils allow you to experience the deep, rich cloud that SMOK is known for. They have a wattage range of 60-100W with optimal performance between 80-90W. The V12 Prince Triple Mesh are also wicked with top-shelf pure organic cotton for the best vaping experience.
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the centre of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil OHM||0.15 OHM|
|Coil/Wire Type||Cotton, Kanthal|
|Compatible Tank||SMOK TFV12 Prince|
|Draw Type||Direct Lung (DL), Sub Ohm|