Esmoker 510-T Case Kit
As low as CA$34.99 Earn up to 211 Reward Points
Introducing our NEW & IMPROVED 510-T E-Cigarette Case Kit!! It holds 1.0ml of e-liquid and features 4 airflow holes for a smoother vape. The new 510-T is the same size as traditional cigarettes measuring at 10cm in length making it one of the smallest devices that fits comfortably in your pocket. It vapes automatically so there is no need to push any buttons which gives the same sensation as taking a draw from a traditional cigarette. The new 510-T also features a 360 anti-leaking design and is refillable making it highly efficient and cost effective. To charge simply screw in the battery to the USB charger that is included. The end of the battery lights up red, an indication that your battery is dying is decreased vapor production. It takes 1-2 hours to fully charge a 510-T E-Cigarette. The new 510-T is recommended for those looking for a mouth to lung (MTL) vape which is most commonly associated with how a cigarette is smoked given its higher resistant coil options. The 510-T has a bigger battery capacity at 170mAh. The 510-T Case Kit is ideal for light-moderate ?smokers as each 510-T battery is equivalent to 3-5 cigarettes per charge. The 510-T has replaceable coils which should be changed approximately every 3 weeks depending on usage. You can tell by the taste, if you start to experience a burnt flavour or you aren't getting any vapour production it's an indication that its time to change your coil.
Add a Pack of 510-T Coils HERE!
* Special features of 510-T device: battery is a rechargeable, energy saving battery. It has a constant output of 3.6V and has safety protection. It usually takes 1-2 hours to fully charge. The 510-T battery has protection to prevent overcharging and when the battery is fully charged, charging will stop automatically
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.