JoyeTech EX DL Coils-0.5ohm

JoyeTech EX DL Coils-0.5ohm

JoyeTech EX DL Coils-0.5ohm

JoyeTech EX DL Coils-0.5ohm

SMOK NORD Mesh Coils-0.6 OHM

SMOK NORD Mesh Coils-0.6 OHM

Voopoo UFORCE U4 0.23ohm Coils

Voopoo UFORCE U4 0.23ohm Coils

JoyeTech EX DL Coils-0.5ohm

CA$14.99
Availability: In stock
Only 5 left
SKU
JoyeTech EX DL Coils-0.5ohm
Reward Points You will earn 22 Points for purchasing this product.

Joyetech Exceed coils deliver maximum airflow and vapor production. The Joyetech EX 0.5 Coils are made with kanthal wire and cotton allowing you to use your device in both wattage mode. They also tend to last a bit longer and can be used under high wattage.  The Exceed Coils will satisfy vapers looking for a direct to lung ("DL") draw.  Direct to lung inhale is drawing in the vapour directly to lungs similar to smoking a shisha or hookah as opposed to a traditional cigarette. The vapour is dense, produces big clouds and is commonly referred to as “sub-ohm vaping”. Sub-ohm can be defined as a coil that is below 1.0ohm.The higher density vapour will give a more intense throat hit so it’s important to reduce the level of nicotine to 3-6mg or it may be too strong. Also it’s good to take into consideration the VG/PG (Vegetable Glycerin/Propylene Glycol) consistency of your e-liquid.  It’s best to use an e-liquid that has a lower PG ratio and a higher VG ratio.  PG provides a harsher throat hit, while VG adds to vapour density.

Includes:

1 x Pack of Joyetech Exceed coils 0.5ohm DL (Recommended wattage is 20-35W (5pcs/pkg)

Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.

Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.

Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.

Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.

More Information
Colour Black
Coil OHM 0.5 OHM
Coil/Wire Type Cotton, Kanthal
Brand Joyetech
Compatible Tank Joyetech Exceed D22
Draw Type Direct Lung (DL)
Watts/Temp 25w-35w
We found other products you might like!