Uwell Nunchaku Tank
The Uwell Nunchaku Sub-Ohm Tank is a revolutionary tank following the successful Valyrian and Crown series, integrating an elegantly chassis design with 5mL max juice capacity, dual bottom airflow, and the utilization of the plug-pull Pro-FCOS Coil Technology. The Nunchaku Tank measures 25mm in diameter within an aggressive design element with protective metal cage sleeve and grooved bottom base to create a striking impression. The tank reservoir has a maximum capacity of 5 milliliters, conveniently refilled via patented threaded top-fill system to expose the filling port. An improvement in chimney and structural design within the bottom base with a condensation holder to minimize the leakage potential. The new Pro-FCOS Coil (Professional Flavor Optimizing adopts the Plug-Pull mechanism for an ergonomic replacement process and a Claptonized A1 central wires for an optimal balance of flavor and vapor production. Airflow for the Nunchaku Sub-Ohm Tank is configured around the base of the chassis, providing ample airflow.
The Kit Includes:
1×Extra quartz glass
1×0.25Ω coil (installed)
1×Pack of replacement O-rings
1×Drip tip cover(to cover the drip tip when it is not used)
Tank Capacity: 5 ml
Material: stainless steel & quartz glass & copper & silicone
Size: diameter 25.2 mm × height 49.6 mmPlug-pull coils, easy to replace.
Separate condensation holder, easy to clean.
The unique flavor testing technology from UWELL, perfect the flavor profile.
Large clouds with low wattage, power-saving and juice efficient.
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil/Wire Type||Cotton, Stainless Steel (SS316)|
|Draw Type||Direct Lung (DL), Sub Ohm|
|Tank Base Diameter||25mm|
|Thread Type||510 Thread|
|Airflow and Filling Method||Top-Fill, Bottom Airflow, Adjustable Airfow|