Vaporesso Gen 220w Kit
As low as CA$114.99 Earn up to 542 Reward Points
Vaporesso is back with revolutionary technology to change the vaping game forever. Introducing the new Vaporesso Gen Kit, a dual battery mod not only for the pros but suitable for any type of vaper. Intergrated with the new Vaporesso AXON chipset, this allows for fast charging supporting up to 2.5A current, fast firing in less than 0.001s, and the ALL NEW Pulse Mode. Pulse Mode provides any vaper incredibly long flavorful rips from your mod, firing every 0.02s to prevent dry hits.
The device is built with a very simple intelligent user interface with an exterior premium coating, giving it a soft rubber coat yet the surface is smooth to touch. The last coating provides scratch resistance and flame resistance as well.
Accompanying the Vaporesso Gen Mod, the Vaporesso Skrr-S makes the perfect companion providing a generous 8ml e-liquid capacity and is rated very highly amongst all peers for its flavor, vapor production, and the exclusive Vaporesso QF coils. The Vaporesso QF coils are highly compatible for many vapers because of the bullet shaped interior which prevents liquid from spiting back.
The Vaporesso Skrr-S Tank is compatible with any Vaporesso GT coils or Vaporesso QF coils.
- AXON Chipset
- Pulse Mode
- SKRR-S Tank
- QF Coil
- Ergonomic Exterior Material
- Kit Dimensions: 146mm (H) x 30mm (W) x 54mm (D)
- Charging Current: 2.5A
- Battery Capacity: 2 x 18650 Lithium Ion Batteries
- Display: 0.91" OLED
- Power Range: 5w-220w
- Resistance Range: 0.03~5Ω
- 1 x Vaporesso Gen Mod
- 1 x SKRR-S Tank (8ml)
- 1 x QF Meshed Coil
- 1 x QF Strip Coil
- 1 x Replacement Glass Tube (5ml)
- 2 x O-Ring
- 1 x USB Cable
- 1 x User Guide
- 1 x Warranty Card
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible. For Ceramic Coils the process is very similar however they require a longer to saturate before you take your first puff.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a 20-30 minutes, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Battery Specs||Mod, Removable Battery, 18650|
|Charging Style||Micro USB Cable, Passthrough, External|
|Draw Type||Direct Lung (DL), Sub Ohm|