Voopoo UFORCE U4 0.23ohm Coils

Voopoo UFORCE U4 0.23ohm Coils

Voopoo UFORCE N3 0.2ohm Coils

Voopoo UFORCE N3 0.2ohm Coils

Berserker 1.8OHM MTL Coils

Berserker 1.8OHM MTL Coils

Voopoo UFORCE U4 0.23ohm Coils

CA$20.99
Availability: In stock
Only 8 left
SKU
Voopoo UFORCE U4 0.23ohm Coils
Reward Points You will earn 52 Points for purchasing this product.

The Voopoo UFORCE T2 is Voopoo's newest installment in their UForce series tank. From another galaxy, the Voopoo UFORCE T2 has transitioned over to a "transformer" theme to defeat all "deceptive" cloud chasing cravings. The Voopoo UFORCE T2 utilizes the UFORCE series coils which are compatible with the Voopoo UFORCE T1 as well.

The Voopoo UFORCE U4 0.23ohm coil features a dual vertical coil in wattage mode at 50w-120w (best between: 60w-80w) and will satisfy any vapers looking for a ("DTL" draw. Direct to lung inhale is drawing in the vapour directly to lungs similar to smoking a shisha or hookah as opposed to a traditional cigarette. The vapour is dense, produces big clouds and is commonly referred to as “sub-ohm vaping”. Sub-ohm can be defined as a coil that is below 1.0ohm.The higher density vapour will give a more intense throat hit so it’s important to reduce the level of nicotine to 3-6mg or it may be too strong. Also it’s good to take into consideration the VG/PG (Vegetable Glycerin/Propylene Glycol) consistency of your e-liquid.  It’s best to use an e-liquid that has a lower PG ratio and a higher VG ratio.  PG provides a harsher throat hit, while VG adds to vapour density.

Included:
5 x UForce U4 0.23ohm Coil

Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.

Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.

Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.

Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.


More Information
Coil OHM 0.23 OHM
Coil/Wire Type Cotton, Kanthal
Brand Voopoo
Compatible Tank Voopoo Uforce, Voopoo UForce T2
Draw Type Direct Lung (DL), Sub Ohm
Watts/Temp 45w-80w
We found other products you might like!