You will earn 28 Points for purchasing this product.The Geekvape Aegis Boost Pod has a 4.5mL juice capacity and is refillable. Aegis Boosts Replacement Pod comes with both 1 x 0.6ohm coil and 1x 0.4ohm coil as well as an additional DL mouth piece to be used with the 0.4ohm Mesh coil to allow for more open draw. The Aegis Boost coils are plug 'n' play and you can adjust the airflow dial on the device to find your preferred vapor production.
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
