SMOK RPM MTL Mesh Coils-0.3ohm

SMOK RPM MTL Mesh Coils-0.3ohm

Vaporesso GTX Coils-1.2Ohm

Vaporesso GTX Coils-1.2Ohm

SMOK RPM MTL Mesh Coils-0.3ohm

CA$22.99
Availability: In stock
Only 13 left
SKU
SMOK RPM MTL Mesh Coils-0.3ohm
Reward Points You will earn 57 Points for purchasing this product.

The Smok RPM Mesh Coil 0.4ohm are replacement coils for the Smok RPM40. The coils are rated to fire at 25w of power. The Smok RPM coils are very simple to replace with the easy plug and pull system.
 

These coils are meant to fit the Smok RPM Standard Pod.

Featured:

  • Plug and Pull Coils; Easy Replacement Process
  • Resistance: 0.4ohm
  • Coil Material: Kanthal Mesh
  • Wattage: 25w

Included:

  • 5 x Smok RPM Mesh Coils 0.4ohm
     

Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.

Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.

Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.

Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.

More Information
Coil OHM 0.4 OHM
Coil/Wire Type Cotton, Kanthal, Mesh
Brand Smoktech
Draw Type Direct Lung (DL), Sub Ohm