Geekvape Aegis Boost Mesh Coil-0.6ohm

Geekvape Aegis Boost Mesh Coil-0.6ohm

VooPoo PNP Mesh Coils-VM1 0.3ohm

VooPoo PNP Mesh Coils-VM1 0.3ohm

Geekvape Aegis Boost Mesh Coil-0.4ohm

Geekvape Aegis Boost Mesh Coil-0.4ohm

Geekvape Aegis Boost Mesh Coil-0.6ohm

CA$17.99
Availability: In stock
Only 16 left
SKU
Geekvape Aegis Boost Mesh Coil-0.6ohm
Reward Points You will earn 44 Points for purchasing this product.
The Geekvape Aegis Boost Pod has two plug 'n' play replaceable mesh coils options designed for MTL (0.6ohm Mesh Coil) and DL vaping (0.4ohm Mesh Coil)
 
Includes:
5 pcs x Geekvape Aegis Boost Mesh Coil-0.6ohm Pack (Rated 15W-25W for MTL) 
 

Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible.

Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the cotton and wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.

Step 2. Attach your tank and fill with e-liquid then leave it to stand for a minute or two, so that the juice in the tank gets soaked up by the coil/atomizer too.

Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.

 
More Information
Coil OHM 0.6 OHM
Coil/Wire Type Cotton, Mesh
Brand GeekVape
Draw Type Mouth To Lung (MTL)
Watts/Temp 15w-25w
We found other products you might like!